CUSTOMERS MAY EXPERIENCE SOME DELAYS IN SHIPPING... WE APPRECIATE ALL OF YOU AND HOPE YOU ARE ALL SAFE 🙏

MINNIDIP HOW TO

TIPS AND TRICKS

STEP 1 | USING AND AIR PUMP or A BLOW DRIER

USING AN AIR PUMP

 

USING A BLOW DRYER (MUST BE SET TO COOL)

 

STEP 2 | INFLATE WITH BREATH


 

!! IMPORTANT !!

CHECK YOUR VALVES
IF THERE IS A GAP BETWEEN THE BLACK PLUG AND OPEN PORT, AIR CAN SLOWLY LEAK OUT OVER TIME… ESPECIALLY THE TOP RING ONCE THE POOL IS FILLED WITH WATER AND THE BOTTOM TWO RINGS EXPAND IN DIAMETER. IF THE VALVE IS NOT CLOSED TIGHTLY PRIOR TO FILLING WITH WATER, IT CAN BECOME LOOSE ONCE WATER IS ADDED. IF YOUR TOP RING GOES FLAT, FILL WITH AIR AND MAKE CERTAIN THE VALVE IS PINCHED COMPLETELY SHUT PRIOR TO TUCKING IT INTO THE POOL.

!! IMPORTANT !!

INFLATION AND USE OF TUFTED COLLECTION

1. DO NOT OVER-INFLATE:

DO NOT ATTEMPT TO REMOVE ALL WRINKLES FROM THE POOL WALLS WHEN INFLATING. AIR AND VINYL EXPANDS IN THE HEAT AND IT WILL EXPAND ONCE IT WARMS UP IN HOT OUTDOOR TEMPS, ESPECIALLY ONCE FILLED WITH WATER. SO IF IT’S OVER-INFLATED, IT CAN STRAIN THE VERTICAL TUFTS, CAUSING THEM TO POP. NEVER USE AN AIR COMPRESSOR TO INFLATE, ONLY A STANDARD AIR PUMP.

 

2. ONLY PLACE ON LEVEL GROUND:

DO NOT SET UP YOUR TUFTED POOL ON ANY UNEVEN SURFACE AS WATER WILL PUSH TO ONE SIDE AS THE VINYL STRETCHES WHEN IT WARMS UP. IN HOT TEMPERATURES, THE VINYL WILL STRETCH, ESPECIALLY AS WATER WARMS UP. IF SET UP ON ANYTHING EXCEPT A COMPLETELY LEVEL SURFACE, WATER CAN PUSH ONE SIDE OF THE WALL CAUSING IT TO STRETCH AND WATER FLOW OVER.